Yup, like Charlie said, adaptive headlights was a coupe only thing. Hopefully it's a little easier than it sounds. I bought the 2 cd set off Ebay a while back that supposedly has some instructions included and with the instructions here someday I'll give it a shot and see what happens. That's so far over my head that I'm afraid I'd just end up frustrated even trying. It's from reading things like that that I haven't even attempted to install those programs yet. I think I'll fiddle with SSS Progman next. V57, You lose your coding options from V44 but I'm just looking to get DIS for diagnostics. In there, you press ctrl+prnt scrn > vi ediagbias.ini and check that the remote host is 192.168.68.1 and the remote name is diaghead save the ini file and reboot. Once it's done you have to double check the ediagbias.ini on the VM side by going to the Calibration touch shield option. I installed over the DIS v44 by going to administration > installation > v57 cd and waited forever for it to install. I upgraded to v57 on DIS to allow it to read E90s as well. Your zhp is becoming better and better :D

Car Detailing and Show & Shine Prep sponsored by Autogeek.I was kidding about the rain sensor.

Car Audio & Electronics sponsored by Bavsound.

Tire & Wheel Forum sponsored by The Tire Rack.

Suspension Tech and Handling sponsored by.

Professional Motorsports sponsored by Bimmerworld.

Track, Auto-X & Drag Racing sponsored by.

General BMW and Automotive Discussion sponsored by Intercity Lines.Quick Navigation Diagnostic Software Go Top Install ISTA D (the Rheingold version is easiest), configured to use your DCAN interface and try diagnosing your car.Īs I said earlier, not all K+DCAN interfaces work and the ones with white circuit boards have a particularly bad reputation. Try the interface on another car (ideally a 2009 or 2010 model) and, if successfulģ. Set your interface and OBD.ini com ports to COM3 and see if you can establish communication (you will probably need to be using EDIABAS v7.*.* for this car, which rules out using DIS)Ģ. The other issue is that both DIS v57 and INPA will probably be too old to contain the file versions required for your car unless they have been manually updated.

You can Google and download MPROG v3.5 which will allow you to read the EEPROM data from your interface. As 328 Power said, port must be set to COM3 in OBD.ini this is the setting I use with my One Stop Electronics K+DCAN interface and DIS v57 when working on my 2008 E70 but does not address whether the programming of the EEPROM in your interface is correct or whether the interface works.

Revtor profile for ncs expert windows xp